Whistle Responder

Posted in Sound sensor, on 2015-07-16

Circuit diagram:

Whistle Responder

Parts:

  • R1_____________22K 1/4W Resistor
  • R2_____________10K 1/4W Resistor
  • R3______________4M7 1/4W Resistor
  • R4,R8_________100K 1/4W Resistors
  • R5____________220R 1/4W Resistor
  • R6____________330K 1/4W Resistor
  • R7_____________47K 1/4W Resistor
  • R9______________2M2 1/4W Resistor
  • R10_____________1M5 1/4W Resistor
  • C1,C5__________47nF 63V Polyester or Ceramic Capacitors
  • C2,C3__________10nF 63V Polyester Capacitors
  • C4,C6___________1µF 63V Electrolytic Capacitors
  • D1,D2________1N4148 75V 150mA Diodes
  • IC1____________4049 Hex Inverter IC
  • Q1____________BC337 45V 800mA NPN Transistor
  • MIC1_________Miniature electret microphone
  • BZ1__________Piezo sounder (incorporating 3KHz oscillator)
  • B1___________2.8 or 3V Battery (see notes)

Device purpose:

Some 20 years ago it was common to see small key-holders emitting an intermittent beep for a couple of seconds after its owner whistled. These devices contained a special purpose IC and therefore were not suited to home construction. The present circuit is designed around a general purpose hex-inverter CMos IC and, using miniature components and button clock-type batteries can be enclosed in a matchbox. It is primarily a gadget, but everyone will be able to find suitable applications.

Circuit operation:

This device beeps intermittently for about two seconds when a person in a range of around 10 meters emits a whistle. The first two inverters contained in IC1 are used as audio amplifiers. IC1A amplifies consistently the signal picked-up by the small electret-microphone and IC1B acts as a band-pass filter, its frequency being centered at about 1.8KHz. The filter is required in order to select a specific frequency, the whistle's one, stopping other frequencies that would cause undesired beeper operation. IC1C is wired as a Schmitt trigger, squaring the incoming audio signal. IC1D is a 2 second-delay monostable driving the astable formed by IC1E & IC1F. This oscillator generates a 3 to 5Hz square wave feeding Q1 and BZ1, thus providing intermittent beeper operation.

Notes:

  • Power supply range: 2.6 to 3.6 Volts.
  • Standing current: 150µA.
  • Depending on dimensions of your box, you can choose from a wide variety of battery types:
  • 2 x 1.5 V batteries type: AA, AAA, AAAA, button clock-type, photo-camera type & others.
  • 2 x 1.4 V mercury batteries, button clock-type.
  • 1 x 3 V or 1 x 3.6 V Lithium cells.

If you like this page, please consider sharing

Credits

Source