IR Remote Control Extender Mark 3

Posted in Infrared (IR), on 2015-05-03

Description

This Mark3 version of the Infra Red extender is a special version designed to control appliances that use high frequency modulated IR remote controls.

IR Remote Control Extender Mark 3 Circuit Diagram

Notes

IR appliances use pulses (control signals) sent over a modulated IR carrier wave. The carrier wave may be modulated at various frequencies, 36-38KHz being the most popular.Some Satellite receivers use even higher frequencies than this. The IR1 remote module receives an infra red signal and separates control pulses from the modulation. To re-transmit, a 555 timer is configured as an astable oscillator. The 555 timer is controlled by the signal on the reset pin, high generating a carrier and low no carrier. Each control pulse turns on the oscillator for the duration of a logic high signal and off for a logic 0 signal, thereby creating a newly modulated IR signal. The IR module, part number IR1 is available from Harrison Electronics in the UK, IR1 may not be listed in their catalogue but if you ask for an IR1, they will send you the correct part. The IR1 arrives in a small aluminium case, the connections viewed from underneath are shown below:

Infra Red Module, IR1 Pinout

IR Remote Control Extender Mark 3 IR module pinout

Harrison Electronics have limited supplies of the IR1 but as a replcement a standard IR module like the TSOP1838 may be used. The pinout is shown below:

IR Remote Control Extender Mark 3 TSOP1838  Pinout

The carrier frequency is determined by R1 and C3, values shown work at 39.7 kHz, but these may be altered to provide different carrier frequencies. The final CMOS 4049 invertor ensures that under "no signal" conditions both LED's are also off. 

Parts List:

  • C1 100u 10V
  • C2 100n polyester
  • C3 120p silver mica
  • C4 100n polyester
  • R1 150k
  • R2 2k2k
  • R3 1k
  • R4 47R 1W
  • Q1 BC109C
  • IC1 LM7805 
  • IC2 555
  • IC3 IR1 module from Harrison Electronics or TSOP1838
  • IC4 4049 CMOS Invertor LED1 Red LED (or any visible colour)
  • LED2 TIL38 or part YH70M from Maplin Electronics

PCB Layout (courtesy of Claudio from Italy):

First the component side of the board is shown below.

IR Remote Control Extender Mark 3 PCB

And now thw pcb itself.

IR Remote Control Extender Mark 3 PCB

The Mark 3 circuit is an improvement over the Mark 1 and 2 circuits, however the drive from Q1 inverts the polarity of the output pulse. In some cases this can cause problems so the output stage is rewired as an emitter follower. This is the basis for the Mark 4 circuit. If you still have problems then I would recommend trying the Mark 4 circuit.

If you like this page, please consider sharing

Credits

Source , Author: IR Remote Control Extender Mark 3